Remote Control Spot Light LED

Description

Effective Lumen: 1600LM

This spotlight consists of 12x3W ultra bring LED bulbs. It is highly durable and excelling energy saver.

The light projection extends to 200 feet away. The light is equipped with overload/overheat and over rotate protection. This spot light can rotate vertically 70 degrees and horizontally 340 degrees. It is equipped with remote control for ease of use and convenience.

The spotlight must be mounted on a flat smooth surface for optimal use. Keep the light away from locations where sails, line anchors or other dangers might cause damage to the light. You will need access to the underside of the location chosen and that location needs to be drilled.  Please ensure that no wires or other structures are present where the screws need to be drilled into.

It is best to mount light as far forward and as high as permitted in order to minimise glare The gasket on the back cover of this booklet must be used to mark the locations of the four base mounting holes and the centre wire harness hole onto the mounting surface. Drill for 1/8” pilot holes into the marked points. Position the white circular mounting gasket on the base of the light while ensuring that the wire harness exits through the centre hole in the gasket. Lead the wire from the base of the light through the centre pilot holes and around the wire harness that penetrates the mount surface

Wire Connections: Red wire of cable must be connect to the red wire of the spotlight and the same to the black wire of the cable to the black wire of the spotlight

Secure the light on the mounting surface with the lens facing forward. Align the four holes in the light base and the mounting gasket with the four corner holes drilled  into the mounting surface. Fasten the spotlight securely using for M5 self tapping screws. Do not over tighten

Initial Remote Control Programming 

• Please press and hold any one of the size buttons on the remote control
• While holding the button down, connect the red wire to the positive terminal and the black wire to the negative terminal
• After 10 seconds, please release the button being pressed. The remote control will be programmed after button is release
• The remote control will be fully operational

Size: 205 (L) x 176 (W) X 252 (H) mm
Weight: 1.9 kg, (4.2 lbs)
Material: Body Made of UV PC, Base Made of UV PA
Housing Colour: White
Operation: Remote Controlled
Beam Angle: 5°
Elevation Angle 22° up, 48° down
Rotation Speed: 8-10° per second (12 VDC), 12-14° per second (24VDC)
Elevation Speed: 11-14° per second (12VDC), 19-21° per second (24 VDC)
Power Cable Length: 4m (15 feet)
Carton Dimension: 10 x 9 x 9”(25.4 x 22.9 x 22.9 cm)
Carton Weight: 3.2 kg (7lbs)