Ocean Tech Bulkhead Engine Bilge Blower – 24V –

Description

Air Flow: 3680 L/Min (130 CFM)
Power Source: DC 24V/2.5A
Dimensions: (LxWxH) 188x143x212mm (7.41″x5.63″x8.35″)
Intake Pipe: 75mm

Continuous rated centrifugal blower

Constructed withPA6 nylon material certified by RINA prividing a very strong flange mount.

t
• Approved for continous opoperation

t

• Ignition protected to ISO 8846

t

• Stainless metal parts

Specifications:
Air Flow: 280 m³/h (4666 L.Min)
Power Source: DC 24V/2.0A

Dimensions: (LxWxH) 200x165x195mm
Inlet/outlet Pipe: 75mm

Blower is mounted on flat bulkhead surface In highest part of compartment free from spray or deck wash. Cut an hole in bulkhead and secure blower with washers and screws dia. 6 ( NOTICE: Tighten screws evenly to avoid flange damage). Use the suitable discharge fitting so that static pressure of blower will not be affected by change in wind direction. Route inlet ductlng with as few bends as possible to lower 1/3 of the bilqe compartment where vapors are likely to accumulate. Be sure ducting is positioned below top of engine stringers but not so low as to become submerged in bilge water. Locate pickup to take advantage of natural air flow direction.