Made from marine grade stainless steel 316, these can be used as a marine mooring swivel fitting for connection into a mooring line.
-
Stainless steel 316 twist shackle is usually somewhat longer than the average and features a 90deg twist so the top of the loop is perpendicular to the pin. They are designed for application where a more secure tightening pin is required. Excellent used in a shade sail design, combined with a thimble dee ring onto oblong eye plate.
-
Plastimo Iris 50 Hand Bearing Compass allows you to read a bearing without shifting your eyes off your mark. This small hand bearing compass lets you get more accurate bearings faster and without eyestrain. Its dial and needle are photo-luminescent, optimising night time use without the need for batteries - just recharge it under the sun, Housed in a robust, soft, nonslip shell, it’s ruggedly built with a soft expansion diaphragm to prevent leaks and bubbles.
. -
Tru Designs Aquavent® has been designed and manufactured in New Zealand for use in Marine applications.
Vented loops are commonly used for inlet and discharge pipes on toilet installations below the water line. Our Aquavent is moulded in a glass reinforced nylon composite, with a silicon bleed valve. The bleed valve allows air into the system to stop syphoning yet seals effectively when water or fluid pass through.
The advantage with our vented loops over others, is that the internal diameter is the same throughout the bend - meaning there is no restriction.
The Aquavent can be used as a holding tank vent by replacing the bleed valve fitting with a tube that is connected to a deck level vent.
-
Lenco #101 Power Cylinder
Standard replacement actuator / ram to suit most standard lenco trim tab kits.
The Lenco ballscrew design is more reliable, three times more powerful and features an instant response, which makes them very user friendly compared to typical hydraulics.
Lenco fast response electric actuators are fully submersible with all plug & play waterproof Deutsch connections.
Stroke travel: 57mm
Overall length tip to tip when retracted: 30.80cm
Cable length supplied: 1.83cm
The entire Lenco Actuator is fully submersible, maintenance free and sealed for life.
Lenco trim tabs and switches carry a 3-year limited warranty from the date of original purchase.